Ripple noise is often generated on Phoenix Contact power distribution system. This noise will interfere with the surrounding high-speed equipment and may lead to the misoperation of the chip. If there is not enough stable power supply to support the behavior of high-speed components, it will be unpredictable. Power integrity analysis mainly discusses and solves the stability of power supply.

对于理想的电源分配系统传输路径阻抗为零，在电源平面上任何一点的电位都是保持恒定，并等于系统供给电压而实际的电源分配系统，由于各种噪声干扰的存在，电源分配系统上的电位会有波动，有时甚至很严重影响系统的正常工作。

For the ideal power distribution system, the transmission path impedance is zero, and the potential at any point on the power plane remains constant and equal to the system supply voltage. In the actual power distribution system, due to the existence of various noise interference, the potential on the power distribution system will fluctuate, sometimes even seriously affect the normal operation of the system.

菲尼克斯电源不稳定的主要表现形式就是同步开关噪声，是指高速开关器件状态切换时产生的瞬态交变电流，在经过回流路径上存在电感时，形成的交流压降所以也称为噪声。

The main manifestation of Phoenix Contact power supply instability is synchronous switching noise, which refers to the AC voltage drop formed by the transient alternating current generated during the state switching of high-speed switching devices and when there is inductance on the return path, so it is also called noise.

如果电源反弹噪声的相位与地反弹噪声相反，会使高电平信号上噪声波形幅度加倍。电压调节模块是供电的源端，转换电压到另一个电压。某元件的使用一个参考电压和反馈回路来监测负载电压，从而达到调节输出电流的作用。

If the phase of the power bounce noise is opposite to the ground bounce noise, the amplitude of the noise waveform on the high-level signal will be doubled. The voltage regulation module is the source of power supply and converts the voltage to another voltage. A component uses a reference voltage and feedback loop to monitor the load voltage, so as to adjust the output current.